SmartDevil Full Glue UV Tempered Glass for Samsung Galaxy S22 Ultra

• Turn off your phone, Paste the non-slip mat on the back of the phone
• Wipe the screen evenly with leveling wipes
• Wipe again with ①wet wipes
• Dry the screen with ②dry wipes until there is no water mark
• Remove dust from the screen with ③dust absorber
• Install the frame from top to bottom, keep balance on all sides, make sure the frame fits your phone perfectly
• Set up a bracket at the bottom of the frame and make sure to push it to the end
• Important step: The level must be balanced on all sides
  (The bubble of the level is between the scale lines on both sides)
• Be sure to place absorbent cotton around the frame. A total of 5 pieces of absorbent cotton, up and down, left and right, and speakers are required
  (Otherwise, the spilled glue may damage your phone)
• Drop the glue on the red circle (As shown in the video)
• Rotate the white cover for 4 turns and remove it. Hold the middle of tube in your left hand, make its opening is facing down.
• Make the tube 5mm above the screen
• Rotate the small cap of the tube, and the liquid glue will come out automatically. Make the liquid glue on the screen in a circle
• Tear off the isolation film
• Place the screen protector stays close to the top of the frame
• The bottom of the screen protector is placed on the bracket
• Take the handle of the bracket and move it out slowly, so that the screen protector can be put down slowly.
• The glue will spread evenly on the whole screen.
• Connect the power and turn on the UV light
• Slide left and right until the light goes out automatically, so that it shines evenly on the screen to dry the glue
• Press the screen gently with your fingers and remove the install frame vertically upwards
• After removing the frame, wipe the glue that spills around the screen
• Turn on the UV light to illuminate both sides of the curved screen. Finished

See Other Cover & Protectors