Description
SmartDevil Full Glue UV Tempered Glass for Samsung Galaxy S23 Ultra
- Turn off your phone, Paste the non-slip mat on the back of the phone
- Wipe the screen evenly with leveling wipes
- Wipe again with ①wet wipes
- Dry the screen with ②dry wipes until there is no water mark
- Remove dust from the screen with ③dust absorber
- Install the frame from top to bottom, keep balance on all sides, make sure the frame fits your phone perfectly
- Set up a bracket at the bottom of the frame and make sure to push it to the end
- Important step: The level must be balanced on all sides
(The bubble of the level is between the scale lines on both sides) - Be sure to place absorbent cotton around the frame. A total of 5 pieces of absorbent cotton, up and down, left and right, and speakers are required
(Otherwise, the spilled glue may damage your phone) - Drop the glue on the red circle (As shown in the video)
- Rotate the white cover for 4 turns and remove it. Hold the middle of tube in your left hand, make its opening is facing down.
- Make the tube 5mm above the screen
- Rotate the small cap of the tube, and the liquid glue will come out automatically. Make the liquid glue on the screen in a circle
- Tear off the isolation film
- Place the screen protector stays close to the top of the frame
- The bottom of the screen protector is placed on the bracket
- Take the handle of the bracket and move it out slowly, so that the screen protector can be put down slowly.
- The glue will spread evenly on the whole screen.
- Connect the power and turn on the UV light
- Slide left and right until the light goes out automatically, so that it shines evenly on the screen to dry the glue
- Press the screen gently with your fingers and remove the install frame vertically upwards
- After removing the frame, wipe the glue that spills around the screen
- Turn on the UV light to illuminate both sides of the curved screen. Finished